Stan Meyers H Bridge Driver
This H Bridge can run the gate and or the power to transistor solid state
for example during the gate it can back switch and pull electrons out of the water to a load,( the reverse setting)
VIC-Transformer not work "correctly" with Unipolar "DC" Signal! At low voltage, all is Ok! But when increase the voltage, "Self-induction" peak have limit (Core saturation), and more increasing the "Input voltage" not increase Voltage to the Cell! As look, with "AC" Sinusoidal or "AC" Square Signal, VIC effectivity NOT LIMIT!
My circuit diagram (full size,
"Improved" Circuit Diagram -
Added HCF4098): http://alfa.kachi-snimka.info/images-...
At 40 Volts to H-Bridge, current is only 200 mA!
My VIC dimentions:
Primary coil: 3 layers X 70 turns = 210 turns Resistivity - 7,5 ohm Induction: On Air core (no ferrite) - 1,24 mH
On Ferrite core - 114 mH C1, C2
Secondary coil: 13 layers X 80 turns = 1040 turns
Resistivity - 37,5 ohm
Induction: On Air core (no ferrite) - 31,2 mH
On Ferrite core - 1750 mH
The Voltages to C1, C2 and Secondary coils are equal !!!
For High Voltage "stability", must use "Double coated enameled copper wire": http://static2.tme.eu/products_pics/0...
Original Meyer`s "Big Bobbin" use other way for INSULATION (Like Flyback transformer ): http://static.wixstatic.com/media/75c...
How to Automatically winding High Voltage transformers:
I'm a paragraph. Click here to add your own text and edit me. It's easy.
NAV NOTES H Bridgee & All Switching
set the gate as follows:-
The duty cycle of the gate needs to be at 90% in favor of 'on' and 10% in favor of 'off'. BUT...the entire length of the gate time on and off must be three seconds exact. This is the error of our ways.
Can we keep ration but accelerate the repetitions to as fasts as possible?
UnIvesal Switch on this foum is vry similar Concept t Babock Switch ,
We know the Vic make cell goes to 1.6 Kv so eec electron extract has to use a UNiversal switch
or you going to have Mosfet popcorn on the 2 way switch the magnetisium might mess up the H bridge.
So we learn with H bridge abve test and the Advance to the Universal Switch this is why this
Hydrogen Hot Rod Website exisis to teach Please make a Donation today and help us stay here.
We draw up a specific H bridge totem daughter board with ration adjust or speed adjust of reptitions and post it here So to control gate fast silicon mosfets (to Nav ration 90/10) and also switch back the electron extract to 9xd during gate off ? make usable voltage.
The faster we do the gates and switch back to electron extract caps better the result if ratio kept
If we keep Ratio 90 on 10 off we can in fact increase speed and stay true to the forumla?
We know there are high performance results on to electrons and atoms ionization
with fast pulse and gate best is picosecond rates.
to use such we would jump specifically of 9xa/9xb and have inverted signal
so we can jump 9XA and use like Mike did above and have invert signal to stay tru to the meyers
PS from Deep study of pulsing red leds the best ionization rate at low wattage into water spiting = best results are in picosecond
do this driver could also be added to the 9xd and run leds in fast rate